Ordering More Accessories; Cleaning And Storage - Coffeemaxx JK40401 Gebrauchsanleitung

11. Move the On/Off switch to position 0 when the brewing process has ended and no more
espresso is trickling into the espresso pot. The brewing process need up to 10 minutes.
12. Remove the mains plug from the mains socket.
13. Remove the espresso maker from the base station and serve your espresso.
14. Allow the espresso maker to cool down completely after each use before you use it
again or clean it.

Ordering More Accessories

To order more original spare parts/accessories, visit our website: www.service-shopping.de

Cleaning and Storage

CAUTION!
❐ Remove the plug from the mains socket before cleaning the device.
❐ Allow the device to cool down completely before cleaning it!
❐ Never immerse the base station or the water reservoir in water or other liquids! Make
sure that the base station, the bottom of the water reservoir, the cable and plug cannot
fall into water or become wet.
❐ Not suitable for cleaning in the dishwasher!
❐ Do not use corrosive or abrasive cleaning agents to clean the device. These could damage
the surface.
• Unscrew the espresso maker and remove the sieve insert. Dispose of the espresso pow-
der in an environmentally friendly manner.
• Remove any remaining water from the water reservoir. If necessary, wipe the water
reservoir with a damp cloth and then wipe it down with a dry cloth.
• If necessary, wipe the base station with a damp cloth and then wipe it down with a dry
cloth.
• Rinse the espresso pot (without the water reservoir!) and the sieve inserts if necessary
with warm water and mild detergent.
• Only reassemble the espresso maker once all of the parts are completely dry.
• Store the espresso maker in a dry, clean place.
10. Move the On/Off switch to position 1. The operat-
ing lamp lights up when the device is switched on. The
brewing process begins a few moments after the device
is switched on.
19