Electrical Diagram; List Of Components - Zummo Z1 Bedienungsanleitung

Blocked machine
Breakage of guide plate
Not enough juice is being
extracted from the fruit
The second half of the
orange turns around
The orange rebounds in
the cup and misses the
blade
Oranges pop out from the
paddle
For any advice or to request spare parts, you should state the model and serial number of your machine (Fig.
5).
15

ELECTRICAL DIAGRAM

1 Fuse
2 Power switch
3 Circuit board
4 Superior protection sensor
5 Front-cover micro-switch
6 Tray micro-switch
16

LIST OF COMPONENTS

0502007A COVER CLASP
0503001 FEEDER PADDLE
0504013 PRESS PLATE FASTENER
0504014-1 CUP SLIDE
0504020 PLASTIC WASHER 7,5/15 X 1,5
To unblock the machine, use the 3mm Allen key to the right of the lower
grille of the machine. Insert it into the hole on the right-hand side and, with
the machine unplugged, turn it in a clockwise direction until you can raise
the cup and release the blockage. IMPORTANT: before plugging in the
machine, make sure you have removed the key from its fitting.
The Peel Extracting Bands are loose or broken and peel is piling up in the
Juicer tray.
The nut of the cup is not tight enough.
The ball in the squeezer tray is loose.
The skin of the fruit is too thin. Check that the washer is fitted underneath
the ball; fit a maximum of one washer.
Orange may be too small for the cup and ball set being used. Fit the
medium set, or the cup with the elastic accessory.
Check the size of the oranges in the calibrator.
Orange may be too large for the cup and ball set being used. Fit the large
set with the elastic accessory.
Check the size of the oranges in the calibrator.
The paddle shaft is too dry; proceed to grease it. (Fig. 15)
7 Motor
8 Bin sensor
9 Counter micro-switch
10 Condenser
11 Photocell
0505016 PEEL EXTRACTING BANDS
0506005/1 FRONT COVER MICRO HOOP
0506006/1 SQUEEZING TRAY-MICRO CLAMP
0506007 MICRO (SHORT)
0506008 MICRO (LONG)
19