Operation - switel BCC 50 Bedienungsanleitung

5 Operation

1. Transmitter unit
In order that the transmitter (unit for the baby) and receiver (unit for
the adult) can communicate with each other, they must both be set to
the same memory channel (M1−M15).
Sensitivity control (VOX)
The sensitivity control is used to set the noise level at which the
transmitter should begin transmitting noises detected.
1 kHz beep signal
In order to be sure the transmitter is working properly, activate this
feature so that it sends a beep signal every 30 seconds.
Automatic monitoring
The transmitter can be set up so that it activates the microphone for
5 seconds every 5 minutes and transmits the noises detected to the
receiver.
Alert signal
The transmitter can be set up so that it sends an alert signal before
transmitting the noises detected.
The display flashes while completing the settings de-
scribed below; it returns to a constant display after a few
seconds. This means that the setting made has been
saved.
Switch on
Switch off
Set the mem-
ory channel
Set the switch (3) to I".
Note: The display indicates the current
channel or memory channel.
Set the switch (3) to 0".
Note: The display goes out.
Press the Menu button (5) twice;
use buttons (7,4) to select a mem−
ory channel (M1−M15).
Note: M" appears in the display.
43