Operation - switel BCE27 Bedienungsanleitung

2. Operating using the power adapter plug
Only use adapters which bear a CE certificate.
S
Connect the power adapter plug to the 9 VDC jack on the
transmitter unit and to the power socket.
S
Connect the power adapter plug to the 9 VDC jack on the
receiver unit and to the power socket.
S
Set the channel selector on the transmitter and receiver units to
the same channel (A or B) (Fig. III).
S
If you do not intend to use the units for a longer period of
time, remove all the batteries. Otherwise, they could leak.
S
It is recommended to use the 9 V power adapter plugs for
both units.
S
If both units are equipped with batteries and the adapter plugs
are inserted in both, the units only operate via the batteries
following a power failure when the adapter plugs are
disconnected from the transmitter and receiver units.
7

Operation

1. Transmitter unit
S
Ensure that the power adapter plug is connected correctly or the
batteries have been inserted properly.
S
Position the transmitter unit near the baby and ensure that the
microphone is pointing towards the baby to enable optimum
transmission (Fig. IV).
Ensure that the unit is out of reach of the baby. Never place
the unit in the baby's bed or playpen!
S
When the integrated microphone detects sounds (range
1 to 2 m), the transmitter unit starts transmitting signals to the
receiver unit automatically. When no further noise is detected,
transmission is stopped.
32