Werbung
•
Overophedning i
•
transmissionskassen.
•
•
Kraftig gnistdannelse fra
•
motoren.
Rengøring
Rengør regelmæssigt maskinhusene med en blød klud, helst efter hver brug. Sørg for, at
ventilationsåbningerne er fri for støv og snavs. Fjern vedholdende snavs ved hjælp af en klud,
der er fugtet med sæbelud. Brug aldrig opløsningsmidler, som f.eks. benzin, sprit, salmiak
osv., da sådanne kemikalier beskadiger de syntetiske dele.
Fejl
Skulle en fejl opstå, f.eks. pga. slidtage af en enhed, kontakt venligst serviceadressen på
garantibeviset. På bagsiden af denne manual finder du en tegning med alle dele, der kan bestilles.
Miljø
For at undgå transportbeskadigelse leveres maskinen i en solid emballage. Emballagen er så
vidt muligt lavet af genbrugsmateriale. Genbrug derfor emballagen.
Defekte og/eller kasserede elektriske eller elektroniske maskiner skal afleveres på
en genbrugsplads.
Garanti
DK
Se venligst garantibetingelserne på garantikortet, som er vedlagt separat.
76
Overophedning af
•
Nedsæt belastningen, eller
maskinen eller sløvt bor
slib boret.
Nedsat spænding.
•
Juster
forsyningsspændingen
Undersøg kulbørsterne for
slitage.
2. SAFETY INSTRUCTIONS
In this operator's guide the following symbols are used:
Read instructions carefully
In accordance with essential applicable safety standards of European directives
Class II machine – Double insulation – You don't need any earthed plug.
Denotes risk of personal injury, loss of life or damage to the tool in case of non-
observance of the instructions in this manual.
Indicates electrical shock hazard.
Immediately unplug the plug from the mains electricity in the case that the cord
gets damaged and during maintenance
Wear ear and eye protection
Faulty and/or discarded electrical or electronic apparatus have to be collected at
the appropriate recycling locations.
Special safety instructions
•
Wear a hard safety helmet, safety glasses and/or face shield. It is also highly
recommended that you wear a dust mask, ear protectors and thickly padded gloves.
•
Be sure the bit is secured in place before operation.
•
Under normal operation, the tool is designed to produce vibration. Check tightness of
screws carefully before operation to avoid a breakdown or accident.
•
In cold weather or when the tool has not been used for a long time, let the tool warm up for
several minutes by operating it under no load. This will loosen up the lubrication. Without
proper warm-up hammering operation is difficult.
•
Always be sure you have firm footing. Be sure no one is below when using the tool in high
locations.
•
Hold the tool firmly with both hands.
•
Keep hands away from moving parts.
•
Do not point the tool at any one in the area when operating. The bit could fly out and injure
someone seriously.
•
Do not touch the bit or parts close to the bit immediately after operation; they may be
extremely hot and could burn your skin.
Ferm
Ferm
GB
05
Werbung
Kapitel
