E) Bnc-Video-Inputs „V-In1" And „V-In2 - Renkforce 419700 Bedienungsanleitung

e) BNC-Video-Inputs „V-IN1" and „V-IN2"
When the two BNC video inputs are selected and you push the button „MENU", the associated OSD menu
is displayed. The OSD menu is operated as follows:
• The buttons „t" or „u" on the IR-remote control (or „UP/+" and „DOWN/-" on the monitor) are used to
select between the submenu „PICTURE", „OSD", „FUNCTION" and „AUDIO".
• The button „q" or „p" on the IR-remote control (or „SOURCE" on the monitor) can be used to select the
functions.
• The buttons „t" or „u" on the IR-remote control (or „UP/+" and „DOWN/-" on the monitor) are used to
select the respective set values.
• If you have completed the settings, the button „MENU" will take you back to the selection of the sub-
menu „PICTURE", „OSD", „FUNCTION" and „AUDIO" .
Leave the OSD menu by pushing the button „MENU" again. Alternatively, wait without pushing a button
until the display of the OSD menu disappears on its own.
Submenu „PICTURE"
The following functions are available:
„CONTRAST"
„BRIGHTNESS"
„HUE"
„SATURATION"
„SHARPNESS"
„COLOR TEMP"
„SCALE"
„PICTURE MODE"
38
Contrast
Brightness
Colour value (only for NTSC, otherwise „HUE" is displayed grey and cannot be
selected)
Colour saturation
Image sharpness
Colour temperature
This can be used to set the image format („FULL" = 4:3 full screen, „16:9" =
image format 16:9, depending on the image fed in)
Image mode