Commissioning; Inserting Battery In The Ir Remote Control, Battery Replacement; B) Setup And Mounting - Renkforce 419700 Bedienungsanleitung

7. Commissioning

a) Inserting Battery in the IR Remote Control, Battery Replacement
The battery may already be inserted in the IR remote control. If a small plastic strip is present
in the battery compartment, pull it out. It serves to protect against premature discharge of the
battery.
• Check during first commissioning whether the battery compartment of the IR remote control has a plastic
protective strip. If so, pull it out. The IR remote control is then ready for use.
• A battery change is required if the range of the IR remote control drops or the monitor no longer reacts
to the IR remote control at all.
• The locking clip at the battery compartment must be unlatched, e.g. with a flat screwdriver, upon which
the battery holder and battery can be pulled out.
Replace the empty battery with a new one of type CR2025. Always observe the correct polarity (plus/+
and minus/-) when inserting the battery. The plus pole of the battery is marked with the icon „+" and must
point towards the bottom of the IR remote control.
Push the battery holder back into the IR remote control. Observe correct orientation. Do not apply any
force!
b) Setup or Installation
Operation with standing base:
• Push the standing base on the holder and screw it on.
• The monitor can be set up on a stable, level, sufficiently large area, via the standing base.
Protect valuable furniture surfaces from scratches or pressure points with suitable pads.
Operation with monitor holder:
Alternatively to replacement of the standing base, you may use a suitable monitor holder for wall assembly,
for example (not enclosed in the scope of delivery, available as accessories).
Proceed as follows:
• Remove the standing base from the rear of the monitor.
First disconnect the cover flap from the holder. Then turn the 2 screws below to the left and right out and
remove the standing base.
• The assembly holes at a hole distance of 100 x 75 mm or 100 x 100 mm permits screwing the monitor onto
the monitor holder. Observe the operating instructions for the monitor holder used by you.
Caution!
The screws with which the monitor is attached to the monitor holder must not be too long. When
the screws are too deeply turned into the monitor, the monitor is damaged; loss of warranty/
guarantee! The turning-in depth must not exceed 5 mm.
Furthermore, the monitor holder must be suitable for the monitor weight.
28