Inhaltsverzeichnis
Werbung
English (GB) Safety instructions
Original safety instructions
These safety instructions give a quick overview of
the safety precautions to be taken in connection with
any work on this product.
Observe these safety instructions during handling,
installation, operation, maintenance, service and
repair of this product.
These safety instructions is a supplementary
document, and all safety instructions will appear
again in the relevant sections of the installation and
operating instructions.
Keep these safety instructions at the installation site
for future reference.
Warning
Prior to installation, read these installation
and operating instructions. Installation and
operation must comply with local
regulations and accepted codes of good
practice.
Warning
The use of this product requires
experience with and knowledge of the
product.
Persons with reduced physical, sensory or
mental capabilities must not use this
product, unless they are under supervision
or have been instructed in the use of the
product by a person responsible for their
safety.
Children must not use or play with this
product.
Applications
Warning
Do not use the pump in or at swimming
pools, garden ponds, etc. when there are
persons in the water.
Installation
Warning
The installation of the pump must be
carried out by specially trained persons.
Warning
Care must be taken to ensure that persons
cannot come into contact with the pump
impeller.
Electrical connection
Warning
The pump must be connected to an
external mains switch with a minimum
contact gap of 3 mm in all poles.
As a precaution, all pumps must be
connected to a socket with earth
connection.
Warning
The protective earth of the socket outlet
must be connected to the protective earth
of the pump. The plug must therefore have
the same PE connection system as that of
the socket outlet. If not, use a suitable
adapter.
Warning
The installation must be fitted with an earth
leakage circuit breaker (ELCB) with a
tripping current less than 30 mA.
Maintenance
Warning
Before starting any work on the product,
make sure that the power supply has been
switched off and that it cannot be
accidentally switched on.
Warning
Be careful during dismantling as you will
get access to sharp edges, etc., which
may cause cuts. Wear protective gloves.
Warning
Unilift AP, KP: For safety reasons the inlet
strainer must always be fitted to the pump
during operation.
If a pump has been used for a liquid which
is injurious to health or toxic, the pump will
be classified as contaminated.
Fault finding the product
Warning
Before starting any work on the product,
make sure that the power supply has been
switched off and that it cannot be
accidentally switched on.
Subject to alterations.
5
Werbung
Inhaltsverzeichnis
