Measuring; Selecting The Measuring Mode - Wohler KM 410 Bedienungsanleitung

5.2

Measuring

Fig. 6: Readings
5.2.1 Selecting the mea-
suring mode
Fig. 7: Measuring mode "Air tem-
perature"
After the warm-up-phase the meter starts measur-
ing.
NOTE!
The measured value (CO
fore the meter was switched off will be displayed,
see chapter 5.2.1
The readings are updated every second.
In the lower part of the screen, date and time are
displayed in turns.
If the operating environment changes (ex. from
high to low temperature), it will take 30 seconds
until the correct CO
30 minutes, until the correct relative humidity
readings are indicated.
NOTE!
NOTE! During the CO
the meter close to faces, because the exhalation
can affect the CO
• Press MODE to select the measuring mode.
By pressing MODE repeatedly the display switch-
es from one measuring mode to another. The
following modes are displayed.
CO (carbon dioxide), DP (dew point), WBT (wet
2
bulb temperature), TA (air temperature), %rH
(relative humidity), CO (carbon monoxide).
, CO etc.) selected be-
2
readings are indicated and
2
-measurement do not hold
2
level.
2
Operation
EN
45