Important Safeguards For Electrical Appliances - Gastroback 46007 Bedienungsanleitung

IMPORTANT SAFEGUARDS FOR ELECTRICAL APPLIANCES

The appliance is driven electrically. Place the appliance near a suitable wall power
socket to connect the appliance directly to a protected mains power supply with pro-
tective conductor (earth/ground) connected properly. Ensure that the voltage rating
of your mains power supply corresponds to the voltage requirements of the appliance
(220-240 V, 50 Hz, AC, rated for at least 8 A).
The installation of a residual current operated circuit breaker (r.c.c.b.) with a maxi-
mum rated residual operating current of 30 mA in the supplying electrical circuit is
strongly recommended. If in doubt, contact your electrician for further information.
• Do not use multiple electrical adapters. We recommend avoiding the usage of
extension cords. However, if you wish to use an extension cord, ensure that the
protective conductor is connected properly.
• Do not leave the appliance unattended while connected to the power supply.
Always immediately unplug the appliance after use and before cleaning. Always
grasp the plug when disconnecting the appliance from the power outlet.
• Always handle the power cord with care. Do not place the appliance on a power
cord. Do not let the power cord hang over the edge of the table or counter. Keep
the cable away from any hot surfaces (e.g. sealing band of the appliance). Never
pull, rip, bend, clamp, squish or knot the power cord. Attend to nobody getting
caught in loops of the power cord or pulling the appliance off the work space.
When pulling the plug always catch hold of the enclosure of the plug. Do not
attempt to repair the power cord!
• Do not place or immerse the appliance or power cord in water or any other liquid.
Do not pour or drip any liquids on the appliance or power cord. When liquids are
spilled on the appliance, immediately unplug the appliance and dry it to avoid
risk of electric shock or fire (see ›Care and cleaning‹). Do not attempt to operate
the appliance, when liquids are on or in the electrical section of the appliance.
• The appliance is not intended for continuous operation. Please wait approxima-
tely 30 seconds with the lid open (approximately 2 minutes with the lid closed)
after each sealing process before switching on again. For additional safety the
appliance is fitted with a thermal cut out. In the event of overheating (possible
with room temperature of 35 °C or more, or overvoltage of the power supply) the
appliance will automatically shut down to prevent damage. In this case, unplug
and let the appliance cool down for approximately 20 minutes before operating
the appliance again.
33