Gastroback ADVANCED THERMO Bedienungsanleitung Seite 26

densation, small amounts for moisture on the base may occur. This is normal.
Regularly check the power base and power cord for proper operation. The
pins of the plug and connectors in the middle of the power base and at the
bottom of the kettle must be smooth and clean without any discolouration. Do
not operate the appliance when any part of it is likely to be damaged or is
not working properly.
• Return the appliance to an authorised service centre for examination and
repair, if the appliance is not operating properly or overheating, or was sub-
ject to inadmissible strain (e.g. overheating, mechanical or electric shock,
moisture in the electrical connectors). Unplug the appliance immediately,
when a severe problem occurs during operation (e.g. water overflowing,
overheating). Do not attempt to open or repair the appliance on your own.
• Operate the appliance on a well accessible, heat-resistant, water-resi-
stant, stable, level, dry and suitable large table or counter. Do not place the
appliance on inclined surfaces, where it can tilt, overflow, or fall. Ensure that
the base will stand stable, before placing the kettle on it and operating the
appliance. Do not operate the appliance beneath or below any heat-sensi-
tive or moisture-sensitive materials, boards, or drop-lights to avoid damage
caused by steam, heat, or condensate. During operation keep the appliance
in an appropriate distance of at least 20 cm on each side.
• Do not place any clothes or tissue or other objects under or on the appli-
ance during operation, to avoid risk of fire, electric shock and overheating.
Do not place the appliance near the edge of the table or counter.
• Do not place the appliance or any part of it on or near hot surfaces (e.g.
burner, heater, range, or oven). The appliance is heated by built-in electric
heating elements. Do not place any part of the appliance (e.g. power base,
kettle) on a hot oven or range.
• Do not leave the appliance unattended when connected to the power
supply. Always unplug the appliance when it is not in use, and before
moving or cleaning the appliance. Always leave the appliance cool down
before cleaning. Always ensure that the kettle is filled correctly and the exte-
rior and the electrical connectors of the kettle and power base are dry and
clean, before placing the kettle onto the power base.
• Do not overfill the kettle. Always observe the MAX filling mark in the inte-
26