Installation/Removal Of The Outside Sensor - Eurochron AS 2000 Bedienungsanleitung

Unscrew
the screw
Unscrew
the screw
battery compartment.
4. Remove the front section of the housing.
5. Now set the jumpers according to the addressing table below.
The black areas represent jumpers set in the relevant place
(1, 2, 3).
Unscrew
the screw
6. When finished, close the housing screwing both housing ele-
7. Insert the batteries paying attention to correct polarity, insert the
4.2 Installation / Removal of the outside sensor
Using the enclosed fixture it is easy to install the outside sensor to
25
Nur
ASH
ASH
2000
2000
only
3 2 1
Coding
field
ments together with the three screws.
outside sensor in its mounting and attach the protective cap
again.
3 2 1
Address Adresse
8
7
6
5
4
3
2
1