Saturation Active Carbon/Anti-Grease Filters; Commands (Fig.17) - Beko HCA91844XH Handbuch

3 Use and maintenance
• With any speed entered (excluding Intense
speed where applicable) by pressing C for about
3 seconds the TIMER function is activated for 15
min. At the end of the count the hood turns off
(motor and any lights that are on).
• To deactivate the Timer function, before the
pre-set time, press any key except the F key for
ON/OFF Lights.
D = THIRD SPEED key/ INTENSE
SPEED Function
• Key D also activates the INTENSE SPEED
function.
• The key flashes for the full duration of the
INTENSE SPEED function.
• By pressing the key for 3 seconds the INTENSE
function comes on for 6 minutes.
• At the end of the minutes the engine will start
operating at the previously set speed.
To deactivate the intense speed, before the
pre-set time, press any key except the F key for
ON/OFF Lights.
ATTENTION: Some models only
A
work up to the 3rd speed and,
therefore, do not have the intense
function.
E = ON/OFF LIGHTS key
Saturation Active carbon/
Anti-grease filters
• When the hood is on the LED corresponding to
the A and B keys flash, the anti-grease filters
must be washed.
Once the clean filter is put back the electronic
memory must be reset, with the hood off press
A for 5 sec. , the reset is confirmed by a flashing
of the LED A and B.
• When the hood is on the LED corresponding to C
and E flash, the carbon filters must be washed.
Hood / User Manual
Once the clean filter is put back the electronic
memory must be reset, with the hood off press A
for 5 sec. , the reset is confirmed by a flashing of
the LED C and E.

Commands (Fig.17)

A = Light Key Turn on/off lights.
B = ON/OFF Key Turn on/off the hood.
The equipment switches on at the 1st speed.
To turn off the hood press key B.
C = Display Indicates the speed of the selected
motor and activation of the timer.
D = Key Increases and decreases the speed of
the motor with a cyclical pattern, 1°-2°- 3° ... 1°-
2°- 3° speed.
By pressing the key for 3 seconds the INTENSE
function comes into operation for 6 minutes, on
the C display the number 4 starts flashing.
At the end of the minutes the engine will start
operating at the previously set speed.
To deactivate the intense speed, before the set
time, press the B key and the hood turns off, but
not if the lights are on.
E = Timer key With any speed entered
(excluding Intense speed) by pressing the key the
timer function is activated for 15 min. At the end
of the count the hood turns off (motor and any
lights that are on).
To turn off the Timer function, before the pre-set
time, press the B key and the hood turns off, or by
pressing the timer key again it turns off but the
hood continues to operate.
15 / 123 EN