Installation Of Models Without Decorative Ducts - Extractor Hood; Optional Accessories; Installation Of Models With Decorative Ducts; Filter Hood - Beko HCA91844XH Handbuch

2 Installation instructions
• Fix the 2 top screws K and screw anchors (Fig.3),
without tightening them completely.
• Place the appliance against the wall, align it in
horizontal position and tighten screws K (Fig.7).
• Once the adjustment has been completed, fix
the hood using the 2 screws C (Fig.8).
• When carrying out the fixing operations,
use only screws and screw anchors suited
to the type of wall (e.g. reinforced concrete,
plasterboard etc.).
• If the screws and screw anchors are supplied
with the appliance, make sure that they are
suited to the type of wall to which the hood
must be fixed.
Installation of models without
decorative ducts - extractor
hood
• Remove the 4 screws B as shown in (Fig.9 A).
• Remove both grid E on the air outlet hole and lid
M as shown in (Fig.9 B).
• Connect the hood to the flexible hose (not
supplied) and the hose to the air exhaust hole
previously prepared (Fig.9 C).
• Fix the lid once again by using the 4 screws
previously removed in (Fig.9 A).

Optional accessories

• This model may have decorative ducts as
optional accessories - ask your retailer for
information.
• Before fixing the decorative ducts, remove
both the 4 screws B and lid M, as shown in
(Fig.10A-B).
• A sound-absorbing kit is also available (to be
ordered as an OPTIONAL accessory) in order
to increase the quietness level of the hood.
The sound-absorbing layer must be applied
to the back of the decorative panel. For fixing
operations, refer to the instructions supplied
with the kit.
Hood / User Manual
Installation of models with
decorative ducts
Make sure the electrical power supply is within
the measurements of the decorative connector.
Adjust the width of the support bracket of the
top connector (Fig.11C). Then fix it to the ceiling
so that it is on the same axis as the hood using
screws A (Fig.11C) adhering to the distance from
the ceiling shown in (Fig.11B). Connect flange
C to the air exhaust hole using flexible hose L
(Fig.11D).
Slide the top duct into the bottom duct. Fix the
bottom duct to the hood using screws B (supplied)
(Fig.11E).
Pull out the top duct as far as the bracket and fix it
using screws F (Fig.11C).

Filter hood

Please note:
The filters should be ordered as accessories from
your retailer.
We offer 2 different types of kit which can be used
to transform the EXTRACTOR hood into a FILTER
hood, in accordance with the type of appliance
model purchased. One kit contains extractable
filters (fig. 10) and the other contains circular
filters (fig. 15).
1. If you find a bracket (such as the one indicated
in fig. 14) included in the product packaging,
this should be fixed to the hood using the 6
screws supplied.
To replace the active carbon filters pull lever B
outwards as shown in (Fig.10).
2. If your product is not supplied with a bracket,
this means that the active carbon filter is a
circular version (fig. 15).
The filters should be fitted to the extraction
assembly inside the hood, by centring them
and rotating them 90 degrees, until they click
into place (Fig. 15).
13 / 123 EN