Saturation Active Carbon/Anti-Grease Filters - Beko HCA91844XH Handbuch

3 Use and maintenance
Saturation Active carbon/
Anti-grease filters
• After 30 h of operation, with the hood ON on
display C , the letter F starts to flash which
means that the anti-grease filters have to be
washed.
Once the clean filter is replaced you must reset
the electronic memory, with the hood off press
key B and D for 5 sec. until the display C shows
the letter F fixed for 2 sec.
• After 120 h of operation, with the hood ON on
display C the letter C starts to flash which means
that the carbon filters have to be washed or
replaced.
Once the clean filter is replaced you must do a
double re-set so with the hood off press key B
and D for 5 sec. until the display C shows the
letter F fixed for 2 sec.
Repeat and press key B and D for 5 sec. until
display C shows the letter C fixed for 2 sec. .
The manufacturer declines all
responsibility for eventual damages
caused by breaching the above
warnings.
16 / 123 EN
Hood / User Manual