Preparation For The Assembly Of The Hood Onto The Wall - Beko HCA92844BH Anleitung

3 Installing your appliance
3.2.2 Preparation for the
Assembly of the Hood onto the
Wall
Information required for the preparation of the
installation place for your hood is given below.
1. Mark the surface where assembly template is
going to be hung. (Figure 1)
2. Affix the assembly template onto the
installation place of the hood. (Figure 2)
Hood / User Manual
3. Drill a hole with Ø 8 mm bit on marked points.
(Figure 3)
4. Hammer 3 pieces of Ø 8x40 mm dowels in
drilled holes. Screw 2 pieces of Ø 5x45 mm
hanging screws to dowels hammered above.
There must be a gap of 5 mm between the
screw head and the wall. (Figure 4)
4
11 / 242 EN