Changing The Diamond Saw Blade. See 13.1; Cleaning; Troubleshooting; Disposal - Zipper ZI-FTS115 Originalbetriebssanleitung

15.1.1 Changing the diamond saw blade. see 13.1

15.1.2 Cleaning

Cleaning: The use of paint thinners, gasoline, corrosive chemicals or abrasive
cleaners will result in damage to the surface!
Therefore:
16

TROUBLESHOOTING

Disconnect the machine from the power supply prior to any checks performed at the
machine itself!
Trouble
Engine will not start
Saw blade wobbles
16.1

Disposal

Do not dispose of your waste in the ZI-FTS115. Contact your local
authorities for information regarding the available disposal options.
Improper disposal can lead to contamination of soil, ground water soil
seepage of hazardous and noxious substances, and thus reach finally
through contaminated water into your food supply and your health
you gefährden.Wenn replace your old unit with a new one at your
local dealer, is obligated to take back your old equipment free of
charge for the purpose of proper disposal.
Z.I.P.P.E.R Maschinen Austria  www.Zipper-maschinen.at
Fliesenschneider / Stone cutting machine ZI-FS115
N O T E
When cleaning, use only mild detergent
Possible Cause
 Plug is damaged / defective
 cutting wheel shaft
TROUBLESHOOTING
Solution
 Renew plug from electrical specialist
 Check ball bearings, shaft, flange
and nut.
 Replace if defective
Seite 22