Specifications; Standard Accessories - Hitachi DH 24PC3 Bedienungsanleitung

English
PRECAUTIONS ON USING ROTARY HAMMER
1. Wear ear protections
Exposure to noise can cause hearing loss.
2. Do not touch the bit during or immediately after
operation. The bit becomes very hot during
operation and could cause serious burns.
3. Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.

SPECIFICATIONS

Voltage (by areas)*
Power Input
No-load speed
Full-load impact rate
Capacity: concrete
steel
wood
Weight (without cord and side handle)
* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Plastic case .................................................................. 1
(2) Side handle ................................................................. 1
(3) Depth gauge ............................................................... 1
OPTIONAL ACCESSORIES (sold separately)
1. Drilling anchor holes (rotation + hammering)
Drill bit (Slender shaft)
Drill bit (Slender shaft)
Outer diameter
3.4 mm
3.5 mm
Drill bit (Taper shank) and taper shank adapter
Drill bit (Taper shank)
Outer diameter
11.0 mm
12.3 mm
12.7 mm
14.3 mm
14.5 mm
17.5 mm
21.5 mm
7
Adapter for slender shaft
(SDS-plus shank)
Drill bit (slender shaft)
Effective length
45 mm
Taper shank adapter
(SDS-plus shank)
Cotter
Taper mode
Morse taper (No.1)
Morse taper (No.2)
A-taper
B-taper
4. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
5. Always hold the body handle and side handle of
the power tool firmly. Otherwise the counterforce
produced may result in inaccurate and even
dangerous operation.
6. Wear a dust mask
Do not inhale the harmful dusts generated in drilling
or chiseling operation. The dust can endanger the
health of yourself and bystanders.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
800W*
0 – 1150 min
0 – 4600 min
3.4 – 24 mm
13 mm
32 mm
2.4 kg
Standard accessories are subject to change without
notice.
Overall length
90 mm
Applicable drill bit
Drill bit (taper shank)
Drill bit (taper shank)
Taper shank adapter formed A-taper or B-taper
is provided as an optional accessory, but the
drill bit for it is not provided.
–1
–1
11.0 ~ 17.5 mm
21.5 mm