Nozzle Assembly; Installing Tips - Storch Airless SL 1600 HD Handbuch

Nozzle assembly

1.
Use spray nozzle (A) to
insert seal (B) into guard
(C).
Spraying
1.
Spray test pattern. Adjust
pressure to eliminate hea-
vy edges. Use a smaller
nozzle if pressure adjust-
ment cannot eliminate
heavy edges.
Original instruction
2.
Insert nozzle.
2.
Hold the spray gun perpen-
dicular to the surface while
maintaining a distance of
25-30 cm. Move the spray
gun back and forth. Over-
lap by 50%. Start moving
the gun before pressing
the trigger and release the
trigger before stopping the
gun.
3.
Screw the assembly onto
the spray gun. Tighten it
by hand.
Remove nozzle plug
1.
Release the trigger, enga-
ge the trigger lock (ON).
Rotate the nozzle through
180 degrees. Disengage
the trigger lock (OFF).
Activate the trigger briefly
to remove the clog. Never
point the gun at your hand
or a cloth when doing this!
188
2.
Engage the trigger lock
(ON). Return nozzle to ori-
ginal position. Disengage
the trigger lock (OFF) and
continue spraying.