Pressure Relief, Grounding - Storch Airless SL 1600 HD Handbuch

Container
Solvent and oil-based media: observe local regulations. Use only a conductive metal container on an earthed surface
such as, e.g., concrete.
NOTE:
Do not place the container on non-conductive surfaces such as paper or cardboard, as these can interfere with earth
continuity.
Operation
Procedure for relieving pressure
1.
Turn the ON/OFF switch to
OFF. Wait for 7 seconds.
Earthing a metal container
Connect one end of an earth cable to the container and the other end to a good earth
point, such as a water pipe.
Power requirements
Use an extension cable with an undamaged earth contact. If an extension cable is
necessary, use a 3-wire, 12 AWG cable (2.5 mm2) at the very least.
Earth contact during rinsing or relieving pressure
Hold a metal part of the spray gun firmly to the side of an earthed metal container.
Then trigger the gun.
2.
Lock the gun's trigger lock.
Remove the tip guard and
the tip.
3.
Set the pressure to the
lowest value. Actuate the
spray gun to relieve the
pressure.
185
4.
Insert the bypass tube into
a container and open the
bypass switch (vertical).
Original instruction