Transport, Packaging And Storage - WIKA DELTA-trans DPGT40 Betriebsanleitung

5. Transport, packaging and storage

5. Transport, packaging and storage
5.1 Transport
Check the instrument for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
EN
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g.
change in installation site, sending for repair).
5.3 Storage
Permissible conditions at the place of storage
Storage temperature: -40 ... +70 °C
In order to prevent damage, the following points should be noted for the
storage of the instruments:
Leave the instruments in their original packaging
■
Following any possible removal of the measuring instruments, e.g. for testing,
■
the instrument should again be stored in its original packaging
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust, humidity and corrosive gases
■
Potentially explosive environments, flammable atmosphere
■
12
WARNING!
Before storing the instrument, any residual media must be
removed. This is of particular importance if the medium
is hazardous to health, e.g. caustic, toxic, carcinogenic,
radioactive, etc.
WIKA operating instructions differential pressure gauge, model DPGT40