Operation - Schaudt LAS 1218-2 Bedienungs- Und Montageanleitung

Instruction Manual and Installation Instructions LAS 1218-2
Battery selector switch
Changing the battery
4
The LAS 1218-2 battery charger is for charging suitable batteries during
230V operation or supplying 12V consumers without connected battery with
power.
The device is a primary controlled switch-mode power supply unit. This mo-
dern switching technology achieves high charging performance at a compact
size and low weight.
The battery charger can be used:
as a battery charger for charging the living area battery and for re-
F
charging a connected starter battery
as an additional charger for charging the living area batteries having a
F
higher capacity which match every Schaudt electroblock with a type
LAS charger module
as a power supply unit (up to 18 A) for the 12V consumers connected.
F
No battery is required here.
1.3

Operation

1.3.1 Controls and indicator lamps
The device has no controls which need to be used on a day-to-day basis.
The battery selector switch need only be set correctly on initial use and for a
change of battery.
DANGER!
Y
Risk of explosion!
An incorrect battery selector switch setting poses a risk of explosion
F
due to the formation of electrolytic gases.
ATTENTION!
Y
An incorrectly set battery selector switch damages the living area bat-
F
tery.
Disconnect the battery charger from the mains before adjusting the
F
battery selector switch.
Batteries may only be replaced by qualified personnel.
Follow the battery manufacturer's instructions.
Charging unsuitable types of battery may damage them beyond repair.
It is possible to swap lead acid batteries for lead gel batteries.
Given the lack of ventilation options within the vehicle, changing from lead
gel to lead acid batteries is not possible without additional overhead.
Ask your dealer for advice.
The switching option provided by the battery selector switch ensures opti-
mum charging of the two battery types, lead gel and lead acid. The switch
must be set to the correct battery type -- lead acid or lead gel.
Date: 06.11.2014 810.523 BA / EN