Introduction - Schaudt LAS 1218-2 Bedienungs- Und Montageanleitung

1
2
3
4
810.523 BA / EN
Instruction Manual and Installation Instructions LAS 1218-2
WARNING!
Y
Hot components!
Burns:
Only change blown fuses when the device is completely de-energised.
F
Only replace blown fuses once the cause of the fault has been identi-
F
fied and rectified.
Never bypass or repair fuses.
F
Only use original fuses rated as specified on the device or in these in-
F
structions.
The rear of the device may become hot during operation. Do not
F
touch.
Never store heat sensitive objects close to the device (e.g. tempera-
F
ture sensitive clothes if the device has been installed in a wardrobe).
1.2

Introduction

Fig. 1 LAS 1218-2 battery charger
1 Living area and start battery connectors
2 Battery selector switch
3 Indicator lamps for charging cycle
4 Installation feet
5 Mains cable with earthing type plug or WAGO
This device is not intended to be used by persons (including children)
Y
with limited physical, sensory or mental aptitude or lack of experience
and/or knowledge unless they are supervised by a person responsible for
their safety or have received instruction from this person as to how the
device is used.
Children are to be supervised so as to ensure they do not play with the
Y
device.
This device is intended for installation into a vehicle.
Y
Date: 06.11.2014
5
®
-connector (optional)
3