Bosch PLL 5 Originalbetriebsanleitung Seite 21

OBJ_BUCH-311-006.book Page 21 Wednesday, July 24, 2013 12:56 PM
– For horizontal alignment with the spirit level 7, the aluminium support-
ing surface 8 of the measuring tool must face downward.
– For vertical alignment with the spirit level 6, the exit opening for the la-
ser beam 9 must face upward.
Aligning with the Laser Line
Horizontal Alignment (see figures C–D): Position the measuring tool
with the three supporting points 12 against the wall or with help of the
magnets 14, fasten it to the wall holder 1 or to another magnetic surface.
The aluminium supporting surface 8 of the measuring tool must face
downward. Align the measuring tool horizontally with help of the spirit lev-
el 7. Picture frames or tiles, as an example, can be aligned alongside the
horizontal laser line.
Vertical Alignment (see figure D): Position the measuring tool with the
three supporting points 12 against the wall or with help of the magnets
14, fasten it to the wall holder 1 or to another magnetic surface. The exit
opening for the laser beam 9 must face upward. Align the measuring tool
vertically with help of the spirit level 6. Top and bottom cabinets, as an ex-
ample, can be aligned alongside the vertical laser line.
Alignment off of Reference Points (see figure E): Position the measur-
ing tool with the three supporting points 12 against the wall or with help
of the magnets 14, fasten it to the wall holder 1 or to another magnetic
surface. Turn the measuring tool to any angle in order to align the laser
beam to the reference points. In this manner, as an example, picture
frames can be hung parallel to a stairway or ceiling pitch.
Checking Horizontal/Vertical Lines with the Spirit Levels
(see figure F)
The measuring tool can be used as a contractors level for checking hori-
zontal or vertical lines, e.g., for the level set-up of a washer or a refrigera-
tor. Position the measuring tool with the aluminium supporting surface 8
facing against the surface to be checked. When positioning against hori-
zontal surfaces, the aluminium supporting surface 8 must face down-
ward. When positioning against vertical surfaces, the exit opening for the
laser beam 9 must face upward.
Bosch Power Tools
English | 21
1 609 92A 0FS | (24.7.13)