Connecting The Battery - ROBBE Power Peak Twin EQ-BID Bedienungsanleitung

5.1 CONNECTING ThE BATTERy/ POwER SUPPly
!
Important!!! Before connecting a battery pack, make one last check that all the set para-
meters are correct! The battery may be damaged, explode or catch fire if the settings are
incorrect. To avoid a short-circuit with the banana plugs, always connect the charging leads
to the battery charger first and then to the battery. Ensure correct polarity!
Follow the reverse procedure when disconnecting.
Equalizer connection:
The black wire of the voltage sensor lead from the battery must be connected to the charger
at the arrow marking. The arrow marking indicates the earth pole (negative). Ensure correct
polarity!
This example only serves as a reference and is intended to demonstrate the connection of
the voltage sensor lead to the equalizer.
Note:
For safety reasons, when charging/discharging lithium batteries, one should always
connect the battery voltage sensor lead to the charger!
Do not connect the outputs in parallel and never connect the plus and minus poles
together.
Operating Instructions
Power Peak ® Twin EQ-BID
Output 1 active
Output 2 inactive
The output which is being set-up will
have a light background (Output 1). The
output which is not being adjusted at that
moment, has a dark background (Output
2, see the adjacent illustrated screen
displays).
9
VOLTAGE SENSOR
-
+
-
+S1
+
+S2
+S3