General Safety Advice - ROBBE Power Peak Twin EQ-BID Bedienungsanleitung

15. !

GENERAl SAFETy ADVICE

• Never place the charger and connected batteries on combustible surfaces.
• Never operate the unit in the vicinity of inflammable materials or gases.
• Do not leave the device unattended when in use. . The charger can heat up consi-
derably during normal operation.
• Check for damage to the casing and leads.
• Take particular care when handling battery packs with a large number of cells. Ensure
good insulation to prevent the risk of electric shock.
• The Power Peak® ® Twin EQ-BID is designed only for charging, discharging and equa-
lizing rechargeable NC/NiMH/lead and lithium batteries. Due to the risk of explosion,
do not use the charger to charge dry batteries.
• The charger is designed for operation only for 11-28 DC operation, therefore, never
operate the charger with a different voltage supply.
• Protect the charger from dust, dirt and moisture
• Do not expose the charger to excessively low or high temperatures as well as direct
sunlight.
• Make sure the charger is not exposed to impact, pressure or excessive vibration load.
• Ensure the cooling vents are always clear to allow air to freely circulate.
• When not used for a long periods of time, unplug the charger from the power source and
disconnect any batteries.
• Do not charge rechargeable batteries twice in quick succession.
• Do not charge batteries that are at a high temperature. Allow batteries to cool down to
ambient temperature.
• Only cells of the same capacity and of the same make may be charged together.
• Never charge two NC- NiMH batteries connected in parallel to one output, connect only
one rechargeable battery pack at a time.
• Ensure correct polarity of the battery and avoid short-circuits
• Closely follow the instructions provided by the battery manufacturer.
• • Always take great care to check the settings on the Power Peak® ® Twin EQ-
BID. Incorrect settings can damage the batteries beyond repair.
Autobatterie
Operating Instructions
Power Peak ® Twin EQ-BID
Ausgang nicht mit Eingang verbinden.
Autokarosserie
Lader
31
Akku