Start Charge-Discharge Process; Display During A Charge Process; Display During Charge/Discharge And Cycling Process - ROBBE Power Peak Twin EQ-BID Bedienungsanleitung

6.1

START ChARGE-DISChARGE PROCESS

Before starting the programmed procedure, the battery must be connected with the correct
polarity to output 1 or 2. Use the appropriate charge lead, for example, from the compre-
hensive robbe range.
Note: Lithium batteries should always be charged with the Voltage Sensor lead connected.
7.

DISPlAy DURING A ChARGE PROCESS

7.1

DISPlAy DURING ChARGE/DISChARGE AND CyClING PROCESS

Following the start, the screen changes to the working display, which shows all the impor-
tant values of the running procedure. The illustration shows the working display for a nor-
Pressing the "MODE" button, changes to the 2nd and 3rd screens, where these values
can be read. Pressing the "ESC" button will return to previous screen. The displayed
value for the internal resistance will be automatically calculared by the Power Peak ® Twin
EQ-BID.
Note:
During a charge-discharge process, pressing the "ENTER" button, the current can be
changed using the "DEC" or "INC" buttons. This change applies only for the running pro-
cess and will not be stored.
Operating Instructions
Power Peak ® Twin EQ-BID
Pressing the "ENTER" button for at least 2 seconds starts
the charger operation. A warning signal sounds and the
charger checks that a battery is connected and shows this
in the display screen. The illustration here shows this pro-
cedure. If a battery is not connected, the display will show
an error messadge and an alarm will sound.
mal charge process in "Normal" (L-NORMAL) mode. The
working display is divided into 3 sections.
The discharge process runs in a similar manner.
"DISCHARGE" is shown when checking the battery. The
illustration shows the first screen during a discharge pro-
cess in "Normal" (E-NORMAL) mode.
21