Avisos De Errores - ROBBE Power Peak Twin EQ-BID Bedienungsanleitung

conectada al cargador, sigue cargándose con corriente mínima en la fase trickle. Se
realiza una desconexión de la corriente de carga con una corriente de carga restante de
aprox. 30-40 mA.

14. AVISoS DE ERRoRES

Para garantizar un transcurso seguro del proceso de carga o de descarga, el cargador
Power Peak ® Twin EQ-BID está equipado con dispositivos de seguridad. Cuando se
produce un error, aparece en la pantalla el correspondiente mensaje y el zumbador Piezo
emite un tono de advertencia agudo. Los mensajes de error pueden borrarse con la tecla
'ESC', después de subsanado el error.
[ INPUT VOLTAGE ]
*The input voltage is 10.86 V
*Please check the Input vol-
tage!
[ NO BATTERY ]
*No Battery
is connected to the output.
[ REVERSE POLARITY
*The battery is connected
with reverse polarity to the
output!
[ BREAK ]
*The battery connection
is disconnected.
*Please connect the battery
and connect
[ DATA COMMUNICATION
*Contact the
robbe Service department.
Manual de uso
Power Peak ® Twin EQ-BID
[ SHORT CIRCUIT
The output
has a short circuit
*Please check the Output!
[ VOLTAGE TOO LOW
*Output voltage is
lower than the
selected cell count or Voltage
] [ VOLTAGE TOO HIGH
*Output voltage is
higher than the
selected cell count or Voltage
[ TEMPERATURE SENSOR
*The Temperature sensor
is reverse polarity or defective.
[ BID CHECK SUM
]
BID is defective,
press any button to initialise.
[ BATTERY TEMP. TOO LOW
]
*The battery temperature
is for safe operation too low!
[ BATTERY TEMP. TOO HIGH
]
]
*The battery temperature
is for safe operation too high!
]
[
]
*The internal temperature
is too high!
[ WRITE BID DATA
]
*The Data will
not be stored
in the BID system.
*If this message
is displayed continuously,
replace the
BID System.
]
[EQUALIZER VOLTAGE TOO
HIGH]
Equalizer voltage
is too high.
29
INTERNAL TEMPERATURE
]
]