Electrical Connection; Operating Personnel - Storch ESM 1500 Handbuch

1.1 Electrical connection

The device possesses a voltage range which can pose an electrical hazard to humans and animals. This
should only be screwed and / or disassembled by authorised personnel. Similarly, maintenance and repair
work should only be conducted by electrical specialists and authorised service centres. The buyer / user ope-
rates the device at their own risk and under their own responsibility.
Always remove the mains plug from the socket before working on the machine! Conducting maintenance
procedures or exchanging components when the machine is connected to the power supply can result in
injury to the operator and/or bystander(s).
Keep the cable away from the underside of the machine to prevent it from coming into contact with the
rotary disc. Always keep the cable raised above the machine. If the cable is run-over or damaged by the
machine, it can result in accidents through electric shock. The machine is only suitable for indoor use. Risk
of electric shock! Do not expose the machine to water or the rain.
Only connect the machine with the electrical specifications indicated on the type plate. Check prior to use.
Only connect the machine to approved power cables and plugs. Approved HAR power cables (designation
HO5VV-3x2.5 mm2) and approved plugs (type 2P+T16A-250v) must be used in Europe. If the machine is
used with cables that exhibit an insufficient cross-section and/or excessive length, it can result in personal
injury or damage to property.
Electrical equipment such as relays, protective circuits and the power cable should only be checked by
an authorised electrician. If the voltage circuit triggers repeatedly or is underrated, it can result in death
through electrocution.
Never operate the machine if the cable or plug is damaged. Worn or damaged cables or plugs must be
replaced by a qualified electrician or by an authorised STORCH service station (free technical hotline 0800
– 7867247).
Never disconnect or disable the grounding wire. Use of this machine with an ungrounded electrical circuit
can result in death through electrocution. The machine should be checked by a qualified electrician or an
authorised STORCH service station if the grounding wire is missing or if there is reason to believe that the
electric circuit is not grounded appropriately.
Do not use the machine if the cable is damaged. Do not pull on the cable to move the machine. Using this
machine with a damaged cable can result in electric shock.

1.2 Operating personnel

The operator should be informed about the operation of the machine prior to use. Failure to comply with the
instruction manual before operation, regulation or maintenance procedures could result in personal injury or
damage to property.
Please read and observe all of the safety information. Make sure that the type plate, safety symbols (such
as commands and warnings), precautions and instructions are attached to the machine. Failure to observe,
or non-compliance with the instructions attached to the machine or included in this manual can result in
severe injury and / or damage to property.
When using this machine always wear safety goggles, protective clothing, dust masks and ear protection.
An extremely high intensity noise can be produced during operation, which can cause hearing damage in
the event of prolonged exposure. If protective clothing or devices are not worn/used during operation, it can
result in eye damage or bodily injury. Dust can disperse through the air and be inhaled during operation.
Keep your hands, feet and loose items of clothing well away from the working parts of the machine. The
moving parts of this machine can cause serious injury and / or damage to property.
59