Functional Test - WIKA E-10 Betriebsanleitung

6. Starting, operation

6.6 Functional test

The output signal must be proportional to the pressure. If not, this might point to a
damage of the diaphragm. In that case refer to chapter 8 „Troubleshooting".
WARNING
Open pressure connections only after the system is without pressure!
■
Observe the ambient and working conditions outlined in section 6 table „Speci-
■
fications".
Please make sure that the pressure transmitter is only used within the over load
■
threshold limit at all times!
CAUTION
When touching the pressure transmitter, keep in mind that the surfaces of the
instrument components might get hot during operation.
WIKA Operating instructions, E-10, E-11
EN
19