Inhaltsverzeichnis
Werbung
Switching ON the
appliance
Press the master switch Fig. 2/7, the
green and red pilot lights switch ON (not
all models). Warning signal is emitted (not
all models).
Switching OFF the warning
signal
(not all models).
Press the warning signal OFF button
Fig. 2/9. To ensure that the warning
signal is emitted in the event of a
malfunction, wait until the red pilot light
has gone out and then press the
warning signal OFF button again
Fig. 2/10.
Setting the temperature
Set the temperature with the temperature
selector Fig. 2/6. Higher settings indicate
lower temperatures. We recommend a
medium setting (e.g. 4-5).
If your appliance features a temperature
display, adjust the temperature selector
until the temperature indicator is in the
black area Fig. 3.
Tips
S If the door cannot be opened
immediately after closing the freezer
compartment, please wait 2-3 minutes
until the partial vacuum has equalised.
S The refrigeration system may cause
parts of the freezer shelves to become
quickly covered in hoarfrost. This will
NOT affect the function or power
consumption of the appliance.
The appliance does not require
defrosting until the entire surface of the
freezer shelf is covered in more than 5
mm of hoarfrost or ice.
S To prevent the formation of
condensation near the door seal, the
sides of the housing are heated slightly.
Note ambient
temperature and
ventilation
The appliance can be operated at the
following ambient temperatures
depending on the climatic category" (see
rating plate). (The rating plate can be
found inside the appliance at the bottom
left hand side. Fig 0).
Climatic
Ambient temperature
category
from...to
+10 °C bis 32 °C
SN
+16 °C bis 32 °C
N
+18 °C bis 38 °C
ST
+18 °C bis 43 °C
T
en
21
Werbung
Inhaltsverzeichnis
