Upright AB-46 Electric Betriebsanleitung Seite 6

Leveling the Platform
DO NOT operate the machine if the platform
does not maintain level when elevated.
Note: Platform leveling can be performed only
with the boom stowed and should be done only
to calibrate the automatic leveling system.
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase
speed, counterclockwise to decrease. If you are
not sure what speed to use, start out slow; the
speed can be varied while operating the function.
2. While depressing the foot switch, push the
platform level control switch forward to swing the
platform upward, rearward to swing the platform
downward. Release the switch to stop leveling.
Rotating the Turret
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase
speed, counterclockwise to decrease. If you are
not sure what speed to use, start out slow; the
speed can be varied while operating the function.
2. While depressing the foot switch, turn the turret
rotation control switch counterclockwise to rotate
left, clockwise to rotate right. Release the switch
to stop rotation. Observe the area around the
boom when rotating the turret to avoid any
obstructions.
Elevating the Riser
1. While depressing the foot switch, push the riser
control lever forward to elevate the riser, rear-
ward to lower the riser. Release the control lever
to stop elevating / lowering. The riser will func-
tion at a constant speed, function speed control
setting is not necessary.
Elevating the Upper Boom
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase
speed, counterclockwise to decrease. If you are
not sure what speed to use, start out slow; the
speed can be varied while operating the function.
2. While depressing the foot switch, push the upper
boom control lever forward to elevate the upper
boom, rearward to lower the upper boom. Release
the control lever to stop elevating / lowering.
Extending the Upper Boom
1. While depressing the foot switch, push the boom
extension control lever rearward to extend the
boom, forward to retract the boom. Release the
control lever to stop extending / retracting. The
boom extension will function at a constant speed,
function speed control setting is not necessary.
Elevating the Jib
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase
speed, counterclockwise to decrease. If you are
not sure what speed to use, start out slow; the
speed can be varied while operating the function.
2. While depressing the foot switch, push the jib
control lever forward to elevate the jib, rearward
to lower the jib. Release the control lever to stop
elevating / lowering.
Rotating the Platform
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase
speed, counterclockwise to decrease. If you are
not sure what speed to use, start out slow; the
speed can be varied while operating the function.
2. While depressing the foot switch, turn the plat-
form rotation control switch counterclockwise to
rotate left, clockwise to rotate right. Release the
switch to stop rotation.
6