BASETech 1539300 Bedienungsanleitung Seite 48

When the device is in the holiday mode, the set temperature is
maintained while in this mode. Program settings are only obtained
when the countdown of the holiday mode is at 0 or the Holiday
Mode is reset to 0!
Heat/Cool control
The device can be used as a two-point controller for cooling or heating systems.
When in heat mode, the device switches off as soon as the target temperature
is exceeded and in cool mode as soon as the target temperature is undercut.
When active, the operating mode is indicated by a flame or snowflake. Also a
delay of 5 minutes can be set. This causes a switching hysteresis that protects
the connected systems from rapidly changing between ON (NO) and OFF (NC).
To make the setting, go to the function settings as described under Holiday
mode. Use the buttons "
the cooling system. Press "OK" to confirm.
Press and hold the "SET" button for 3 seconds to activate the delay time. Use
"Select" to change from the time setting "ti" to the function setting "St" and con-
firm with "Set". Use "Select" to toggle between holiday "Ho" and heat/cool "Ht"
and confirm with "Set". Use "Select" to toggle between heating "Ht" and cooling
"Cl" and confirm with "Set". Use "Select" to toggle between delay (d:ON) and
delay (d:oF). Save and close your settings with "OK".
" and " " to select "Ht" for the heating or "CL" for
47