Before Commissioning; Unpacking; Before Startup - Kärcher KM 70/30 C Bp Bedienungsanleitung

Before Commissioning

Unpacking

Open the carton on the side and take
out the appliance.
Assembly
Figure 2, see cover page
Fasten the side brushes with the 3
screws enclosed in the packet.
Batteries
Safety notes regarding the batteries
Please observe the following warning notes
when handling batteries:
Observe the directions on the bat-
tery, in the instructions for use
and in the vehicle operating in-
structions
Wear eye protection
Keep children away from acid and
batteries
Danger of explosion
Fire, sparks, naked flames and
smoking must be strictly avoided
Danger of chemical burns
First aid
Warning note
Disposal
Do not throw the battery into the
regular waste
Please observe the following warning notes
when handling batteries:
Danger
Risk of explosion! Do not put tools or similar
on the battery, i.e. on the terminal poles and
cell connectors.
Danger
Risk of injury! Ensure that wounds never
come into contact with lead. Always clean
your hands after having worked with batter-
ies.
Installing and connecting the battery
Note
There is a built-in battery and charger for
the KM 70/30 C Bp Pack and KM 70/30 C
Bp Pack Adv..
Remove the lid of the battery compart-
ment.
Turn out the screw and remove the bat-
tery cover.
Insert battery in battery mount.
Warning
Pay attention to correct poles.
Attach the connection cable provided with
the pack.
Connect pole terminal (red cable) to
positive pole (+).
Connect pole terminal to negative pole
(-).
Replace the battery cover and fasten
using screw.
Replace the lid of the battery compart-
ment and lock it.
Note
Before removing the battery, make sure
that the negative pole lead is disconnected.
Check that the battery pole and pole termi-
nals are adequately protected with pole
grease.
Warning
Charge the battery before commissioning
the machine.
Charging battery
Danger
Risk of electric shock. Observe supply net-
work and fuse protection - see "Charger".
Only use the charger in dry rooms with suf-
ficient ventilation!
Note
The charging time for an empty battery is
approx. 12 hours.
Danger
Risk of injury! Comply with safety regula-
tions on the handling of batteries. Observe
the directions provided by the manufacturer
of the charger.
(1) Charging process for Bp Pack model
Danger
Risk of injury! The charger should be used
only if the mains cable is in an undamaged
state. Get the manufacturer, the customer
service agent or a qualified person to imme-
diately replace a damaged mains cable.
Note
Normally, the machine is equipped with a
maintenance-free battery.
Insert the plug of the charger into the
socket.
Note
The charger has electronic controls and au-
tomatically switches off the charging proc-
ess. All functions of the machine are
automatically interrupted during the charg-
ing process.
The battery display shows the progress of
the charging process when the plug is in-
serted:
Battery is being charged
Battery is charged
Charger is defective glows red
Battery poled or is not slowly blinks red
connected
Battery defective blinks red fast
(2) Charging process for Bp model
Insert the charging cable of the charger
in the charger box of the sweeper
Plug in mains connector and switch on
charger.
After charging
Bp Pack model:
Remove the mains cable and put it
away:
– Insert the mains plug in the appliance
hood.
or
– Open the battery compartment, stove
the cable with the plug next to the bat-
tery, replace the lid of the battery com-
partment and lock it in.
Bp model:
Switch off the charger and remove the
plug from the socket.
Hang out the charging cable out of the
machine.
Close the cover of the battery compart-
ment.
Maximum battery dimensions
Length Width
175 mm 166 mm
Start up
Adjust the pushing handle
Figure 3, see cover page
Loosen both the star grips.
Pull the pushing handle backward and
tilt it to the desired position.
Press the pushing handle forward and
lock it in.
Tighten the star handles.
glows yellow
glows green
Height
125 mm
English 9