Interrupting Operation; Finish Operation; Maintenance And Care - Kärcher SE 6.100 Betriebsanleitung

Vacuuming hard surfaces
Illustration
 Use your foot to press the reversing
switch of the floor nozzle. The brush
strips at the bottom of the floor nozzle
are extended.
Vacuuming carpeted floors
Illustration
 Use your foot to press the reversing
switch of the floor nozzle. The brush
strips at the bottom of the floor nozzle
are retracted.
 Use the surrounding air separator to
adapt the suction force.
Note:
Close the surrounding air separator
again after use!
Wet vacuum cleaning
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
 Remove the fresh and wastewater con-
tainers, vacuum the wet dirt directly into
the container.
 Use wash nozzles to vacuum moisture
or wetness.
 Once the wastewater container is full,
the appliance switches off automatical-
ly.
Note: Once the appliance shuts off,
switch it off using the vacuum button,
because the suction turbine will other-
wise start running again once you open
the appliance.
If you use a crevice nozzle:
 Attach and secure the adapter for wet/
dry vacuuming. Install the crevice noz-
zle directly to the adapter.
 Switch on the vacuum process.

Interrupting operation

Illustration
 During interruptions in operation, the
suction pipe can be simply clipped into
the accessories storage and removed
again.

Finish operation

 Turn off the appliance.
 Drain the full container.
 Rinse the reservoir thoroughly with
clear water.
 Separate the handle, the spray/suction
hoses and the wash nozzle from each
other; open locking lever to achieve this
(centre position),
 Flush the accessories separately under
running water and let air dry.
 Leave the appliance open to let it dry.
Illustration
 Accessories storage: Suction hose,
suction pipes and accessories can be
comfortably stored on the appliance.
 Storing the appliance. Store the appli-
ance in a dry room.

Maintenance and care

Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorised customer service.
Warning
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.
Clean the spray nozzle
With an uneven spray jet.
Illustration
 Loosen nozzle attachment and pull out,
clean or replace spray nozzle.
Clean the sieve in the fresh water
1 x year or as needed.
Illustration
 Clean sieve.
– 10
EN
reservoir
17