Interrupting Operation; Finish Operation; Maintenance And Care - Kärcher AD 3.000 Bedienungsanleitung

Start up
For vacuuming ashes:
Caution
 Check whether the appliance was emp-
tied and cleaned during the last vacu-
uming cycle.
 Illustration
Connect accessories (hose only).
For dry vacuuming:
* depending on model
 Illustration
Connect accessories (hose, pipes, floor
nozzle, incl. insert).
For wet vacuuming:
* depending on model
 Illustration
Connect accessories (hose, pipes, floor
nozzle, without insert).
Safety Instructions for ash, wet and dry
vacuuming:
 Illustration
Plug in the main plug.
 Illustration
Turn on the machine.
Ash/dry vacuum cleaning
Work only with a dry flat fold filter!
Wet vacuum cleaning
 Attach the accessories to vacuum mois-
ture or wetness to the suction pipes or
directly to the handle.
Caution
The liquid volume of 2.5 litres must not be
exceeded.
Immediately switch the appliance off if foam
forms or liquids escape!
Note: Empty the vacuum cleaner immedi-
ately after wet vacuuming and let it dry.
Otherwise, there is a risk of corrosion.

Interrupting operation

 Turn off the appliance.
-
-

Finish operation

 Turn off the appliance and disconnect
the mains plug.
Empty the container
 Illustration
Remove the appliance head and filter
basket and empty the reservoir.
Storing the appliance
* depending on model
 Illustration
Stow away the mains cable and acces-
sory at the machine. Store the appli-
ance in a dry room.

Maintenance and care

Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorized customer service.
Caution
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.
 Clean the appliance and accessory
parts made of plastic with a commercial
plastic cleaner.
 If required, rinse the container and ac-
cessories with water properly and dry
them before reuse.
Clean flat fold filter
Illustration
 Remove the appliance head. Remove
the frame and filter and knock the dirt
out of the filter. Clean the filter under
running water if necessary. Do not rub
or brush the filter dry.
Let it dry completely prior to installation.
Illustration
 After that, insert the filter first and then
the frame.
Insert and lock the appliance head.
– 9
EN 15