Before Starting The Equipment - EINHELL BT-ML 300 Originalbetriebsanleitung

Anleitung_BT_ML_300_SPK1__ 31.01.13 13:24 Seite 22
GB
Vibration emission value a ≤ 2,5 m/s
h
K uncertainty = 1,5 m/s 2
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
Switch the appliance off when it is not in use.
n
Wear protective gloves.
n
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
22
2

5. Before starting the equipment

5.1 Using for the first time
Make sure that the base on which the equipment
n
is placed can support the weight of the equipment
(approx. 37 kg) and is sufficiently stable for no
vibrations to occur during operation.
All bare parts of the equipment are already well
n
greased in order to protect them from corrosion.
Clean the equipment using a suitable
environmentally friendly cleaning product before
using it for the first time and lubricate the bare
parts with acid-free oil.
If you wish to bolt the equipment to the surface,
n
use the threaded holes in the adjustable feet to
secure the equipment. In this case do not fit the
adjustable feet.
Check that all the screws are secure and that the
n
three-jaw chuck (27) can be turned easily by
hand.
All covers and safety devices must be properly
n
fitted before the equipment is switched on.
Before switching on, make sure that everything
n
has been properly assembled and that moving
parts can move easily.
5.2 Electrical connection
Before you connect the equipment to the mains
n
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
n
adjustments to the equipment.
The equipment may only be operated with single-
n
phase current 230 Volt / 50 Hz. The electric circuit
of the house must be protected by no more than a
16A fuse.
5.3 General instructions for the equipment
The leadscrew (13) is allowed to be used only for
n
thread turning. It must not be used for automatic
longitudinal turning work because the feed will not
cut out if it strikes an obstacle.
Important. Close the safety guard for the jaw
n
chuck before switching the equipment on.