Safety Regulations - EINHELL BT-ML 300 Originalbetriebsanleitung

Anleitung_BT_ML_300_SPK1__ 31.01.13 13:24 Seite 20
GB
Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.

1. Safety regulations

Please refer to the booklet included in delivery for the
safety instructions.
CAUTION
Read all safety regulations and instructions. Any
errors made in following the safety regulations and
instructions may result in an electric shock, fire and/or
serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout and items supplied
(Figure 1/2)
2.1 Layout
1. Speed controller
2. Direction selector switch
3. Emergency Stop switch
4. Hand wheel for longitudinal feed
5. Table slide
6. Compound slide
7. Cross slide
8. Crank with scale for transverse feed (compound
slide)
9. Scale for conical turning
10. Feed locking lever
11. Gearing for feed
12. Crank with scale for hand feed (cross slide)
13. Leadscrew
14. Machine sump
15. Lathe table
16. Crank handle for quill
17. Tailstock
18. Lever for tailstock adjustment
19. Clamp lever for quill
20. Quill with scale
21. Centering pin
22. Safety guard
23. Chuck
20
24. Clamp lever for tool holder
25. Clamp screws for turning tool
26. Clamp jaw
27. Three-jaw chuck
28. Three-jaw chuck clamp screw
29. Gear wheel box
30. Feed direction lever
31. Power cable
32. High / Low speed selector switch
33. Switch guard
34. Motor cover
35. Rear splash guard
36. Tailstock
37. Three-jaw chuck safety cover
38. Clamp jaws
39. Allen key
40. Open-ended wrench
41. Chuck jaw wrench
42. Oil bottle
43. Gear wheels
2.2 Items supplied
Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Metal lathe
n
Clamp jaws
n
Allen key
n
Open-ended wrench
n
Gear wheels
n
Oil bottle
n
Centering pin
n
Original operating instructions
n
Safety information
n