Mounting The Remote Control's Wall Bracket - clage DSX SERVOTRONIC MPS Montageanleitung Für Den Fachhandwerker

DSX
5. Installation
Figure A:
Installation with adhesive tape
Figure B:
Optional installation with dowels and screws

Mounting the remote control's wall bracket

• Before attaching the wall bracket to the wall, ensure that the remote control
has radio contact to the instantaneous water heater from its designated posi-
tion.
• The wall bracket of the remote control can either be attached securely with the
included adhesive tape, after stripping off the protection film (as shown in the fig-
ure A), on a rigid board (e.g. tile) or with suitable dowels (Ø 4 mm) and screws (as
shown in the figure B).
• When using the adhesive tape it is not possible to further adjust the position
because of the strong adherence of the glue. Therefore, pay attention to a horizontal
alignment when attaching it.
• The remote control is magnetically retained at the wall bracket.
Note: Do not expose the remote control to moisture.
26