The Remote Control System - XciteRC Dragon 250 Bedienungsanleitung

Propeller assembly · The remote control system
M1 - M3
counter-clockwise
Unscrew all the nuts from the motor shafts.
Note: the nuts of the clockwise motors M2
and M4 have a left-hand thread.
Lock all rotors with the corresponding nuts.
Note: the nuts of the clockwise motors M2
and M4 have a left-hand thread.

The remote control system

Here you get an overview of the remote control system of your XciteRC Dragon 250 and its various features
and settings. Before the first flight, you should absolutely have read and understood all these functions and
settings.
• Do make sure that the transmitter is turned off - POWER-LED off.
• Now open the battery compartment cover on the backside of the transmitter, therefore slide the cover
XciteRC Dragon 250
M2 - M4
clockwise
Note the marks of the rotors: the top surface of
the rotors is labeled with two points, the bottom
with four.
步 4
WARNING: Tighten the nut firmly – crash
hazard!
EN
21