Flight Control Diagram - XciteRC HotBee 120 3D Bedienungsanleitung

Matters needing attention:
• Please follow this rules:"Open the radio first, connect the Quadcopter power last".After open the radio
power button, please connect the power in 10 seconds, the signal indicator light begins flashing. The
EN
light will be solid after 1-3 seconds, and the four motors will self-checking rotation, then the receiver has
received the signal of the radio successfully, binding finished.
• If more than 10 seconds passed before the power cable was connected binding will fail. When binding
falls, disconnect the battery.
Trouble shooting a flashing receiver LED after connecting the power cable:
Possible causes
Code pairing failed
The throttle stick of the transmitter is not
in the lowest position
The transmitter battery is low and empty Replace transmitter battery and re-codepair (re-bind)
The receiver battery is low and empty
No function in receiver or transmitter

Flight control diagram

Flight in normal status
Mode 1 (throttle stick at right hand)
1. When moving the aileron slick left or right, the
helicopter accordingly flies left or right.
3. When moving the rudder stick left or right, the
head of helicopter accordingly flies left or right.
20
Solutions
Turn transmitter off then on and re-connect power cable of the
receiver
Pull down the throttle stick to the lowest position and re-code
pair
Replace the receiver battery with a fresh pack and re-code
pair
Replace faulty receiver or transmitter and re-code pair
2. When moving the throttle slick up or down, the
helicopter accordingly flies up or down.
4. When moving the elevator stick up or down,
the helicopter accordingly flies forward or back-
ward.
Getting started
15000000 XciteRC Hotbee 3D Quadrocopter