Maintenance And Care - Kawasaki 603.010.010 Originalbetriebsanleitung

The mitre angle and the vertical angle must both
be set for combined mitre cuts.
This process is used, for example, to make picture
frames, for cutting strips and for making crates
using angled side walls and also for roof trusses.
Always test the cut first using a piece of waste
wood before you cut the actual material.

12. Maintenance and care

CAUTION.
- Never attempt to use a saw blade which
exceeds the maximum specified size for the saw.
The saw blade could come into contact with the
safety hood.
- Never use saw blades which are excessively
thick which will prevent contact between the
external saw blade washer and the flattened
parts of the spindle. This means that the saw
blade cannot be secured correctly to the spindle
with the saw blade screw.
- Do not use the saw to cut metal or masonry.
- Please note that the spacers and spindle rings
which may be required are suitable for the
spindle and the saw blade you wish to use.
- The mains cable must be disconnected from the
mains supply.
1. CHANGE SAW BLADES
1) Press the control lever (7) downwards and pull
the release knob (6) to release the sawing arm (5).
The release knob can be locked in the released
position by turning it. Move the sawing arm (5)
into its highest position.
2) Remove the Philips screw which secures the
saw blade screw cover (12). (B20)
3) Pull the moving safety hood (10) downwards
and then swing it upwards together with the saw
blade screw cover (12).
4) If the moving safety hood (10) is above the top,
fixed safety hood (9), the saw blade screw is
accessible.
5) Hold the moving safety hood (10) in its top
position and press the spindle locking button
(23). Turn the saw blade until the spindle locks.
6) Remove the saw blade screw using the
hexagonal wrench (17). (Turn the wrench
clockwise since the saw blade screw has a left-
handed thread).(B21)
7) Remove the external washer and the saw
blade.
Apply a drop of oil to the internal and external
washers at the places in which it is in contact
with the saw blade.
Secure the new saw blade on the spindle. Ensure
that the internal washer is located behind the
saw blade.
CAUTION. Always fit the saw blade so that the
teeth and the arrows printed on the side of the
saw blade point downwards so that the saw
blade will rotate in the correct direction. There is
also an arrow on the top safety hood to show the
direction of rotation of the saw blade. (B22)
8) Fit the external saw blade washer again.
Press the spindle locking button (23) and fit the
saw blade screw again.
9) Tighten the screw with the hexagonal wrench
(17) (turn it anti-clockwise).
Move the moving bottom safety hood (10) and
the saw blade screw cover (12) into the correct
position and tighten the securing screws.
Check whether the safety hood functions
correctly and covers the saw blade when the
sawing arm is lowered.
Connect the saw to the power supply and start
the saw blade to check whether it functions
correctly.
2. MAINTENANCE
23
GB