Special Safety Instructions - Kawasaki 603.010.010 Originalbetriebsanleitung

• Never carry the device by the cable. Only pull
the cable from the receptacle with the plug.
Protect the cable from oil, heat, and sharp
edges. Damaged cables can cause an electric
shock.
• Check the device and power cable for damage
before starting work.
• When plugging in the power plug, make sure
that the operating switch is not located in
position.
• Only use approved extension cables when using
the device outside.
• When using a cable drum, unwind it entirely in
order to prevent the cable from heating up. The
minimum wire gauge is 1.5 mm
• When working outside, the receptacle must be
equipped with a residual current circuit-breaker.
• Pull the plug when you are not using the device
or making adjustments.
• Always guide the cable away from the back of
the tool.

7. Special safety instructions

• Never use the crosscut mitre saw for cutting
materials other than those specified by the
manufacturer.
• Only use the saw if the guards are in the correct
positions and if the saw is in good condition
and has been serviced correctly.
• Ensure that the equipment for swinging the arm
on mitre saws is securely fastened.
• The floor around the machine must be flat, clean
and clear of loose particles such as chips and
off-cuts.
• Ensure that there is reasonable lighting in the
workplace or room.
• The operator must have received adequate
training in the use, setting and operation of the
machine.
• Ensure that you only use spacing discs and
spindle rings which are suitable for the purpose
specified by the manufacturer.
• The laser must not be replaced by a laser of a
different type. Repairs may only be carried out by
the manufacturer of the laser or an authorised
representative.
• Damaged or deformed saw blades must not be
used.
• Replace worn table inserts.
2
. • Use only saw blades which are recommended
by the manufacturer and comply with EN 847-1.
• Do not use saw blades made of high speed
steel.
• The crosscut mitre saw must be connected to a
dust extraction system for sawing wood.
• Always position the workpiece securely on the
machine surface to prevent the workpiece
moving.
• Use an additional support for long workpieces
(for example a table or saw stool) to prevent the
machine from tipping over. Do not ask other
people to hold the workpiece.
• Place the machine on a strong, flat working area
before use.
• Check whether the moving parts of the machine
are in perfect working order and that no parts
are damaged.
• Check the direction of rotation of the motor and
saw blade.
• Replace defective saw blades immediately.
19
GB