Proper Usage; General Safety Instructions - Kawasaki 603.010.010 Originalbetriebsanleitung

5. Proper usage

GB
This machine is designed for crosscutting wood
and plastic in sizes commensurate with the
machine size.
It is not suitable for cutting firewood.
Use only saw blades which are suitable for the
machine. Do not use cutting discs.
The manufacture assumes no liability whatsoever
for improper use or if the machine has been
tampered with.
Give equal attention to the safety instructions,
assembly and operating instructions as well as
prevailing accident preventions regulations.

6. General safety instructions

• Keep your work area clean and well lit to
prevent accidents.
• Don't use electric devices close to flammable
liquids or gasses or in wet or damp environments.
If you fail to observe this, there is a danger
of fire or explosion.
• Never leave the device running unattended.
• Never use the device when you are tired or lack
concentration or if your reactions are impaired
due to consumption of alcohol or medication.
Lack of attention can lead to serious injury.
• Keep the tools clean and in good working order
in order to be able to work better and safer.
• Don't wear bulky clothing or jewellery.
• Make sure you can stand stably and have shoes
that won't slip.
• Use a head cover if you have long hair.
• Loose clothing, jewellery, and long hair can
become entangled in moving parts.
• Always wear safety goggles.
• Wear a dust mask when working with materials
that produce dust.
• Wear ear protection if a lot of noise is produced.
• Persons using the machines must not be
distracted. This could cause one to lose control
over the tool.
• Don't use any device that has a faulty on/off
switch. An electric tool that can no longer be
switched on or off is dangerous and must be
repaired.
• Always switch the device on before coming into
contact with the material.
• Remove keys and adjusting tools before
switching on the device.
• Never overload the machine. If the speed drops,
unload the machine or switch it off. You will
work safer and better with the appropriate
electric tool in a specific area of application.
• Stop the workpiece from turning, for example
with a clamping device or a vice. Don't work
on any workpiece that is too small to clamp in
place. If you hold the workpiece with your hand,
then you can't operate the tool safely.
• Keep electric tools out of the reach of children.
• Only use accessories recommended by the
manufacturer.
• The mains voltage must correspond to the
information on the machine's type plate.
• Avoid body contact to grounded elements, e.g.
pipes, radiators, stoves, and refrigerators, to
prevent an electric shock.
18