Technical Data; Cleaning And Maintenance; Environmental Protection - Kawasaki K-EJS 800 Originalbetriebsanleitung

10. Technical data

GB
Mains voltage:
Power input:
Stroke speed:
Stroke height:
Cutting depth, wood:
Cutting depth, plastic:
Cutting depth, iron:
Miter cut:
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 89,17 dB(A)
pA
K uncertainty 3 dB(A)
pA
L sound power level 100,17 dB(A)
WA
K uncertainty 3 dB (A)
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three
directions) determined in accordance with EN
60745.
Cutting wood
Vibration emission value a
K uncertainty = 1,5 m/s
Cutting sheet metal
Vibration emission value a
K uncertainty = 1,5 m/s
Important!
The vibration value changes according to the area
of application of the electric tool and may exceed
the specified value in exceptional circumstances.

11. Cleaning and maintenance

Always pull out the mains power plug before
starting any cleaning work.
11.1 Cleaning
230 V~ / 50 Hz
800 W
0 – 2900 min
23 mm
85 mm
12 mm
8 mm
up to 45° (left and right)
II /
2.5 kg
2
= 7,077 m/s
h
2
2
= 11,369 m/s
h
2
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
• We recommend that you clean the device
-1
immediately each time you have finished using it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can
seep into the device.
11.2 Carbon brushes
• In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
11.3 Maintenance
• There are no parts inside the equipment which
require additional maintenance.
12. Repairs
Only use accessories and spare parts
recommended by the manufacturer.
If the equipment should fail some day in spite of
our quality controls and your maintenance, only
have it repaired by an authorized electrician.
If the supply cord of the appliance is damaged,
this has to be done by the manufacturer or his
agent or electrician in order to avoid a safety
hazard.

13. Environmental protection

End of life electrical equipment must not
be placed in household waste. Please take
it to a return point. Find out about your
nearest return point from your council or
sales outlet.
22