Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Technische Daten
Abmessungen und Varianten
Durchmesser ×
121 mm × 57 mm
Höhe
Farben
weiß, schwarz
Leistungsdaten
Netzspannung
220 – 240 V
Netzfrequenz
50/60 Hz
Schaltleistung
ohmsche Last
Glühlampen
maximal 2000 W
unkompensiert,
Leuchtstofflampen
induktiv,
maximal 500 VA
cos φ 0,5
elektronische
Leuchstofflampen,
Vorschaltgeräte
Energiesparlampen,
(EVG),
LED-Leuchten, ma-
kapazitativ
ximal 8 × à 58 W,
C ≤ 176 μF,
Gesamtkapazität:
230 VAC
Sensor
Sensortechnik
Passiv-Infrarot,
3 Pyro-Sensoren
Erfassungs-
360°
winkel
Öffnungswinkel
90°
Unterkriech-
vorhanden
schutz
Reichweite und Einstellungen
Erfassungs-
12 m, bei einer
bereich und
Montagehöhe von
Reichweite
2,50 m bis 2,80 m
Schwellen-
2 Lux bis
werte
1000 Lux
Einschaltung
(Tageslichtbetrieb)
Nachlaufzeit,
5 Sekunden bis
stufenlos
15 Minuten
einstellbar
Umgebung
Schutzart
IP 54
Temperatur-
–20 °C bis +50 °C
bereich
- 12 -
Installation instructions
About these instructions
Instructions to take action are shown as
follows:
► Instruction to take action
In the safety advice, the warning symbol
and signal word indicate the severity of
danger:
!
Signal word
Type and source of danger
Measures to avoid dangers
► Read these installation instructions
before installing the product.
Further information
You will find further information at:
www.steinel.com
Proper use
The IS 360-3 outdoor sensor can be
used as an indoor and outdoor motion
detector. Working with three pyro sen-
sors, it detects heat radiated from mov-
ing objects and switches ON lights that
are connected to it. The product is only
suitable for installing on ceilings and
may only be operated in line with the
technical specifications.
All connecting work at the electrical
connections may only be carried out by
a qualified electrician and in compliance
with national regulations.
Product parts (Fig. A)
Holder for ceiling mounting
1 Rating plate
2 Mounting holes
3 Connections
N neutral conductor
Arrow Power supply lead for light
L Mains power supply
4 Cable entries
5 Contact point for protective-
earth conductor
Sensor housing
6 two control dials:
Response threshold and
stay-ON time
7 Housing attachment
with screw
8 Shrouds
9 Cover ring
10 Pilot holes for drainage
11 Fixing material
Checking package contents and
product
► Check to make sure that the product
is complete and undamaged.
► Do not open the housing if it is dam-
aged, and do not repair the product
yourself.
► Carefully pack the damaged product
and send it with a brief description of
the fault and proof of purchase (in-
voice) to a Steinel service station.
- 13 -
Werbung
Inhaltsverzeichnis
