Storage; Waste Disposal And Environmental Protection - Conino Lamborghini PC 41 TL Originalbetriebsanleitung

Guide bar
• Reverse the bar occasionally to prevent partial wear.
• The bar rail should always be a square. Check for
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between them,
the rail is normal. Otherwise, the bar rail is worn. Such
a bar needs to be corrected or replaced.
Guide Bar and Chain
The table contains a list of all possible combinations between bar and chain, indicating those which may be used on
each machine, marked with the symbol "
Pitch Guide Bar
Zoll Length
Inches/cm
3/8" 16"/40cm
3/8" 18"/45cm
For replacement use only above bars and chains. If you use non-approved combinations it may cause serious personal
injury and damage to the machine.

11. Storage

1. Empty the fuel tank and run the engine out of fuel.
2. Empty the oil tank.
3. Clean the entire unit.
4. Store the unit in a dry place out of the reach of
children.
GB | Operating Instructions
* " .
Groove width Code
Inches/mm
0.050"/1.3mm Orgeon
160SDEA041
0.050"/1.3mm Orgeon
180DEA041
16
Chain
Code
Orgeon
91P057X
Orgeon
91P063X
12. Waste disposal and environmental
protection
Never pour remainders of chain lubricant or 2-stroke fuel
mixture in the drain or sewerage system or soil, but dispose
of it in a proper, environmentally friendly way, e.g., at a
special collecting point or dump.
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.
Thoroughly empty the oil/lubricant and fuel tanks and
dispose of the remainders at a special collecting point
or dump. Please also dispose of the device itself at an
according collecting/recycling point. By doing so, plastic
and metal parts can be separated and recycled. Informa-
tion concerning the disposal of materials and devices are
available from your local administration.
1) Ruler
2) Gap
3) No gap
4) Chain tilts
Chain Saw Model
PC 41 TL
*
*