Conino Lamborghini PC 41 TL Originalbetriebsanleitung Seite 36

Cutter setting standards:
WARNING
Be sure to wear safety gloves.
File diameter
Type of chain
91P
91PJ
91VG
E1-
25AP060T
Depth gauge
GB | Operating Instructions
Top plate angle
Vise rotate angle
5/32" 30°
5/32" 30°
5/32" 30°
5/32" 30°
Before filing:
• Make sure the saw chain is held securely.
• Make sure the engine is stopped.
• Use a round file of proper size for your chain.
Chain type:
PC 41 : Oregon 91P
File size: 4.0 mm
Place your file on the cutter and push straight forward.
Keep the file position as illustrated.
After every cutter has been set, check the depth gauge
and file it to the proper level as illustrated.
WARNING
Be sure to round off the front edge to reduce the chance
of kickback or tie-strap breakage.
Make sure every cutter has the same length and edge
angles as shown below.
Down angle Head tilt angle
(55°)
Vise tilt angle Side angle
0°
0°
0°
10°
File
15
Depth gauge
standard
80° 0,025"
80° 0,025"
80° 0,025"
85° 0,025"