Fuel And Chain Oil; Operation - Conino Lamborghini PC 41 TL Originalbetriebsanleitung

IMPORTANT
It is very important to maintain the proper chain tension.
Rapid wear of the guide bar or the chain coming off eas-
ily can be caused by improper tension. Especially when
using a new chain, take good care of it since it should
expand when first used.

6. Fuel and chain oil

Fuel
The engines are lubricated by oil specially formulated
for air-cooled 2-cycle gasoline engine use. If oil is not
available, use an antioxidant added quality oil expressly
labeled for air-cooled 2-cycle engine use.
RECOMMENDED MIXING RATIO GASOLINE 40: OIL 1
These engines are certified to operate on unleaded
gasoline.
WARNING
Gasoline is very flammable. Avoid smok-
ing or bringing any flame or sparks near
fuel. Make sure to stop the engine and
allow it cool before refueling the unit. Se-
lect outdoor bare ground for fueling and
move at least 3 m (10 ft) away from the
fueling point before starting the engine.
IMPORTANT
1. FUEL WITH NO OIL (RAW GASOLINE) – It will
cause severe damage to the engine inner parts very
quickly.
2. OIL FOR 4-CYCLE ENGINE USE or WATER
COOLED 2-CYCLE ENGINE USE – It can cause
spark plug fouling, exhaust port blocking, or piston
ring sticking.
Mixing table for fuel mixture
Petrol 2-stroke oil / 40:1
1 litre 25 ml
5 litres 125 ml
How to mix fuel
1. Measure out the quantities of gasoline and oil to be
mixed.
2. Put some of the gasoline into a clean, approved fuel
container.
3. Pour in all of the oil and agitate well.
4. Pour in the rest of gasoline and agitate again for at
least one minute.
GB | Operating Instructions
5. Put a clear indication on the outside of the container
Chain Oil
Do not use waste or regenerated oil that can cause dam-
age to the oil pump.

7. Operation

Starting engine
1. Untwist and remove the fuel and chain oil caps. Rest
2. Put fuel into the fuel tank to 80% of the full capacity
3. Fasten the fuel and oil caps securely and wipe up
4. Put the switch to the "I" position.
5. Continuously push the priming bulb (4) until fuel
8
to avoid mixing up with gasoline or other containers.
Use special chain saw oil all year
round.
NOTE
the caps on a dustless place.
and chain oil into the oil tank.
any fuel spillage around the unit.
3) Engine switch
comes in the bulb.
1) Oil
2) Fuel