Installing Guide Bar And Saw Chain - Conino Lamborghini PC 41 TL Originalbetriebsanleitung

6) Follow
and maintenance instructions for saw
chain.
7) Only use replacement bars and
chains specified by the manufacturer .

5. Installing guide bar and saw chain

A standard saw unit package contains the items as
shown below:
1) Power unit
2) Saw chain
3) Guide bar
4) Bar protector
5) Plug wrench
6) File
Open the box and install the guide bar and the saw chain
on the power unit as follows.
WARNING
The saw chain has very sharp edges. Use protective
gloves for safety.
1. Pull the guard towards the front handle to check that
the chain brake is not engaged.
2. Loosen the nuts and remove the chain cover.
3. Gear the chain to the sprocket and, while fitting the
saw chain around the guide bar, mount the guide bar
to the power unit.
GB | Operating Instructions
manufacturers sharpening
1) Chain tensioner bolt
2) Chain cover
3) Mounting nut
NOTE
Pay attention to the correct direction of the saw chain.
4. Mount the guide bar then fit the saw chain around the
bar and sprocket.
5. Fit the chain tensioner bolt into the lower hole of the
guide bar, then install the chain cover, and fasten the
mounting nut to finger tightness.
6. While holding up the tip of the bar, adjust the chain
tension by turning the tensioner screw until the tie
straps just touch the lower side of the guide bar.
7. Tighten the nuts securely with the bar tip held up (12
~ 15 Nm). Then check the chain for smooth rotation
and proper tension while moving it by hand. If neces-
sary, readjust with the chain cover loose.
8. Tighten the tensioner screw:
(1) Chain tension adjusting screw:
(2) turn left: Loosen
(3) turn right: Tighten
7
1) Moving direction